Telular SX4D - Manual (Page 34)

Phonecell SX4D Programming - continued
SX4D GSM 900 • SX4D GSM 1800 33 U SER M ANUAL
Enter Periodic Self Test Time Option
The following key sequence is used to program periodic self test time
interval:
Label: SELF TEST TIME
Data: <self-test interval>
The self-test interval is programmed in 1-minute increments from 1 to
65,535. A value of 0 disables periodic self test. If the value is not between 0
and 65,535, inclusive, it will be considered invalid. The factory default is
180.
Enter Dial Tone Type Selection Option
The following key sequence is used to select the dial tone type option:
Label: DIAL TONE TYPE
Data: <dial tone frequency>
The dial tone frequency selection option value is set to 0 to select the North
American dial tone frequency pair (350 + 440 Hz); set to 1 to select
European dial tone frequency (425 Hz). If the dial tone frequency selection
option value is neither 0 nor 1, it is considered invalid and the Phonecell will
not update or store this value; the currently stored value will remain. The
factory default is 1.
Enter In-Call DTMF Signaling Option
The following key sequence is used to select if in-call DTMF signaling
is enabled:
Label: IN CALL DTMF
Data: <in-call DTMF signaling enabled>
The in-call DTMF signaling value is set to 0 for disabled or 1 for
enabled. If the in-call DTMF signaling value is neither 0 nor 1, it is con-
sidered invalid. The factory default is 1.
Enter Mobile Equipment Personalization for SIM
The following key sequence is used to enter the MEP option:
Label: MEP: SIM
Data: <MEP Operation>
* <MEP Password>
MEP operation value is set to 0 to deactivate personalization; 1 to activate
personalization; 2 to disable personalization; 3 is reserved for future use. If
the MEP operation value is not in the range 0 to 3, it is considered invalid.
The MEP password is a special value available only to authorized personnel.
The factory default is set to 0 deactivated.
Enter Mobile Equipment Personalization for Network
The following key sequence is used to enter the MEP option:
Label: MEP: NETWORK
Data: <MEP Operation>
* <MEP Password>
MEP operation value is set to 0 to deactivate personalization; 1 to activate
personalization; 2 to disable personalization; 3 is reserved for future use. If
the MEP operation value is not in the range 0 to 3, it is considered invalid.
The MEP password is a special value available only to authorized personnel.
The factory default is set to 0 deactivated.