TOA Electronics C-RM1000 CU - Manual (Page 19)

19
End
DVR 1
Monitor 1
sequence setting
2 16 1
End
DVR 4
Monitor 1
sequence setting
End
2 16 1
DVR 2
Monitor 1
sequence setting
2 16 1
"DVR" represents the Digital Video Recorder.
[Example] When DVR 1-4 are assigned to Group 1;
Group sequence (Master Monitor 1’s display oder)
8.8. Group Sequential Display
Group sequential displays can be performed if "Group" has been selected in the Cascade Connection setting.
The Monitor 1 sequential display setting is used for the group sequence function.
Notes
• Sequential display settings must be performed in advance for the Digital Video Recorder. For the sequence
setting method, please refer to the instruction manual enclosed with the Digital Video Recorder.
• Set the security function of all digital video recorders within the group to operation level 1, 2 or 3. If the
operation level of a digital video recorder in the system is set to “full-lock,” the group sequence function
cannot be operated.
• Do not turn off the power to the digital video recorder or remote controller while the group sequence function
is in operation. If power is switched off, reactivate the power to all equipment components within the system.
Press the SEQUENCE key after selecting "Group."
The SEQUENCE key lights, commencing the group sequence.
Group sequence operation is shown below.
(1) DVR 1 performs its sequence.
(2) DVR 2 begins its sequence when DVR 1's sequence is completed.
(3) After the group’s last DVR’s sequence is completed, operation
returns to DVR 1, allowing the sequence to cycle through all
DVRs in the group.
S E Q U E N C E
G 1 1 1 5
LCD screen
Lights
SEQUENCE SEQUENCE