Toshiba E-STUDIO900 - Manual (Page 120)

B070/B071 3-4 PTM
3.2 SERVICE PROGRAM MODE TABLES
NOTE: The Service Program Mode is for use only by customer engineers so that they can
properly maintain product quality. If this mode is used by anyone other than a customer
engineer for any reason, data might be deleted or settings might be changed. In such a
case image quality can no longer be guaranteed.
Service Table Key
Notation What it means
[range / default /
step] [–9~+9 / +3.0 / 0.1 mm]
The default setting +3.0 can be adjusted in 0.1mm steps in the
range
±9.
Italics Comments added for reference.
* An asterisk marks the SP’s that are reset to their factory default
settings after an NVRAM reset.
DFU Denotes “Design or Factory Use”. Do not change this value.
Japan only The feature or item is for Japan only. Do not change this value.
SEF Short Edge Feed
LEF Long Edge Feed
NOTE: The intent of this document is to not detail the Service Programs,
please use the SM for that purpose.
3.2.1 COPIER SERVICE PROGRAM MODE TABLES
SP1-nnn Feed
SP Number/Name Function/[Setting]
Leading Edge Registration Adjusts the printing leading edge
registration for feeding from the trays and
duplex tray using the trimming area
pattern (SP2-902-3, No.15).]
Use the “
• / *key to enter the minus ( –)
before entering the value.
The specification is 4
± 2 mm. (
3-17)
001 Copier/LCT Paper Tray B070: [-9.0~+9.0 /-2.6 / 0.1 mm]
B071: [-9.0~+9.0 / -4.0 / 0.1 mm]
002 Duplex Tray B070: [-9.0~+9.0 / -0.3/ 0.1 mm]
B071: [-9.0~+9.0 / -0.4 / 0.1 mm])
003 Copier//LCT Paper Tray (Low
Speed) B070: [-9.0~+9.0 / -3.0 / 0.1 mm]
B071: [-9.0~+9.0 / -2.0 / 0.1 mm]
1001
004 Duplex Tray (Low Speed) [-9.0~+9.0 / 0 / 0.1 mm]
Side-to-side Registration Adjusts the printing side-to-side
registration from the 1st paper feed
station using the trimming area pattern
(SP2-902-3, No.15).
Use the “
• / *key to enter the minus ( –)
before entering the value.
Specification: 0
± 2.0 mm. (
3-17)
001 1st Tray (Copier Tandem Tray) [-9.0~+9.0 / -0.1 / 0.1 mm]
002 2nd Tray (Copier) [-9.0~+9.0 / -0.6/ 0.1 mm]
003 3rd Tray (Copier) [-9.0~+9.0 / -0.3 / 0.1 mm]
1002
004 4th Tray (LCT Tray 1) [-9.0~+9.0 / -0.8 / 0.1 mm]