Toshiba E-STUDIO900 - Manual (Page 82)

PTM 2-57 B070/B071
Toner Bottle Sensors
When placing a toner bottle in the toner bank, the toner bottle pushes the lock arm [A]
downwards. Then the lock arm catches the toner bottle and also pushes down lever
[B]. This causes toner bottle sensor [C] to detect that a bottle has been installed (the
actuator leaves the toner bottle sensor while the bottle is being inserted in the holder).
When replacing a toner bottle, push the toner bottle release lever [D] to release the
lock mechanism. While a toner bottle is supplying toner, the toner bottle opening rod is
pulled to the rear and the lock plate [E] is lowered by the link [F] so that the toner
bottle release lever cannot be pushed. Therefore, the toner bottle that is supplying
toner is always locked in place, and the user cannot pull out the bottle until it is empty.
B070D912.WMF B070D913.WMF
B070D914.WMF
[A]
[D]
[E]
[F]
[C]
[B]