Thales Navigation Mobile Mapper - Manual (Page 27)

21
In the open job, do the following:
- On the Feature List screen, select the grid feature and
press ENTER. On the Grid Setup screen that is now
displayed, set the parameters listed below.
Spacing : Distance between any two consecutive way-
points in any row or column (default: 50 meters or
100 feet, depending on the units used)
Columns : Number of waypoints along the axis facing
you (default: 10; Max.: 100)
Rows : Number of waypoints along the axis perpendic-
ular to the direction you are facing (default: 10; Max.:
100)
Heading : Direction you face when the grid’s columns
extend in front of you and the rows extend to your
right.
To change the above parameters, use the up/down
arrows to move the cursor to each of these fields,
press ENTER, use the up/down arrows to increment/
decrement the highlighted figure, use the right/left
arrows to highlight the next/previous digit in the
field. When you are done with the definition of a
field, press ENTER. Then press the down/up arrow to
access the next field, etc.
Once these parameters have been changed, highlight
OK at the bottom of the screen and press ENTER
- This takes you to the Logging screen from which you
an start logging data as explained previously.
11.Closing a Job
To close a job, all you have to do is open up another job
or turn the receiver off. To open another job, use the
Open
Job option after pressing the MENU button.
Grid Setup screen
In the two examples
above:
Columns=8
Rows=6
Heading=21°
North
(Heading= 0°)
Col
umn
Row
North
Column
Row
Spa
cin
g
Spacing