Thales Navigation Mobile Mapper - Manual (Page 32)

26
Navigation Screens
MobileMapper
offers 7 differ-
ent navigation
screens to help
you locate
yourself or
navigate to
waypoints or
point features
in an existing
job. From any
displayed screen, simply press the NAV button to access
navigation screens. To display the next navigation screen,
press NAV again. The sequence of navigation screens is as
shown above. It can be scrolled in the reverse direction by
pressing ESC once any of these navigation screens is dis-
played.
Each type of navigation screen is presented hereafter.
Map Screen
The Map screen shows a map of the area surrounding your
current location. Use the IN and OUT buttons to adjust the
scale.
The Map screen is always in the Position mode when you ac-
cess this screen. In this mode, your present position is indi-
cated by the large arrow icon in the center of the display. If
you are moving, the arrow will point in the direction that you
are heading. At the bottom of the screen is the scale for the
map displayed and two data fields that can be customized, or
turned off, depending upon your needs.
The present position icon will change to an hourglass when
the MobileMapper is unable to compute a position fix due to
poor signal reception.
Press NAV
Position Screen 2
Large Data Screen
Compass Screen
Map Screen
Satellite Status Screen
Speedometer Screen
Data Screen
Road Screen
Position Screen 1
Press NAV
etc.
The Map screen has two
modes: Position and
Cursor. Use any arrow
key to select Cursor
mode, ESC to return to
Position mode
When a Position screen
is displayed, press the
Left or Right arrow key
to display the other.
Press this key again to
return to the previous
screen.
Except for the Satellite
Status screen, all naviga-
tion screens can be cus-
tomized.
Map screen
in Position mode