Thales Navigation Mobile Mapper - Manual (Page 56)

50
2. Select Map
This option is mainly used to choose the base map used
as background map on the Map screen. The following
parameters can be set on the Change Map screen:
- Basemap : If no SD card containing a specific map is
installed in MobileMapper, then only the Default Map
option can be selected in this field. The default map is
always present in MobileMapper. If an SD card con-
taining specific maps is installed in the receiver, then
you can choose one of them as the one shown on the
Map screen.
- Detail Map : If no SD card containing a specific map is
installed in MobileMapper, then only the Empty
option can be selected in this field as the default map
only has one level of details. If an SD card containing
specific maps is installed in the receiver and you
chose one of them in the previous field, then you can
choose the level of details you wish to see on the Map
screen.
After choosing the desired options for these parameters,
highlight the
Save field at the bottom of the screen using
the down arrow and then press ENTER.
3. Map Setup
This option allows you to set the viewing options for the
Map screen (see page 28).
4. Nav Screens
This option allows you to remove the navigation screens
that you do not need from the navigation screen sequence
that you scroll by pressing NAV repeatedly (see
page 26).
When selecting this option, you are asked to turn off or
on each of the available navigation screens. Choose
“Off” and press ENTER for all these screens that you are
not currently using. Note that the Map screen cannot be
turned off. You must cycle through all the screens in
order to save any changes to the On/Off status of any
screen.
Change Map screen