TechniSat HD S2X - Manual (Page 70)

message Loading EPG and an indication of the EPGplus data already downloaded
in the display panel.
> The downloading procedure can be interrupted by switching the digital receiver on
(On/Standby key).
9.2.6 Selecting radio channels/programmes
Use the same procedure as described in Point 9.2.5 to include radio channels/stations in the
programme guide.
Start update
> To download the EPGplus data, use the up/down arrow keys to mark the Start
download field and confirm with OK.
9.3 Parental control
Your receiver is equipped with a parental control function. This means that important functions
(e.g. calling up the main menu) can be protected from unauthorised use. In addition, recordings
and channels that you have blocked can only be accessed by entering a four-digit PIN code
(unit PIN). To adjust settings in the menu Parental control proceed as follows:
> Use the Menu key to call up the Main menu.
> Use the arrow keys up/down to mark the line Settings.
> Confirm by pressing OK.
The sub-menu Settings will be displayed
> Use the arrow keys up/down to mark the line Parental control.
> Confirm by pressing OK.
The menu Parental control will be displayed.
> Use the arrow keys up/down to move the marker within the menu and to change
the individual positions as indicated. When selecting a menu item, please also note
any messages displayed on screen.
9.3.1 PIN query mode
> In this line, use the arrow keys left/right to set the pin query mode of the
parental control function to Once or Never.
If you set the pin query mode to Once, and have not yet changed the PIN, you will be
requested to change the PIN. To do this, proceed as described in Point 9.3.2.
Never
If you select the setting Never you will never be asked for the PIN. The parental control
function is switched off.
Once
If you select the setting Once you will be asked to enter the PIN when calling up the main menu
or when selecting a blocked channel resp. a blocked hard drive recording. To make matters more
convenient for you, you will be asked for the PIN only once in each operating cycle.
9.3.2 Changing the PIN
The unit PIN code is set to 0000 at the factory.
> Press the OK key.
The menu for changing the unit PIN code will be displayed.
70
9