Tektronix Grass Valley 3000 - Manual (Page 199)

4-61
Keyframe Operations
2. To change the duration of keyframe 1:
a. Position the cursor at keyframe 1. Press KF DUR .
b. Enter a new time of 3 seconds – press ‘ 3 ’ on the E-MEM
Keypad. Press ENTER .
c. Press MOD .
3. To change the duration within an effect (not on a keyframe):
Press GO TO TIME . On the E-MEM Keypad enter a time of 2
seconds, 15 frames, and 1 field. Type: 2 ‘ dot ’ 15 ‘ dot ’ 1 , ENTER .
(You can enter times in seconds, frames, and fields, or just
frames. Both frame and field numbers must be preceded by
the ‘dot.’) If you entered the above time, the LED readout
would indicate:
002: 15. 1
Setting and Adjusting Start Times
Timelines can be moved in relationship with each other by
changing the start time of one timeline.
1. Recall a multiple level effect using M/E 1 and M/E 2.
2. Select Delegates Mode on the Keyframe Menu.
3. “Undelegate” M/E 1 by pressing its’ level enable button.
4. Note that the M/E 1 button goes to low tally, and its’ level
indicator on the Timeline Menu becomes un-highlighted.
5. To adjust the start time:
a. Select Start with the Time Knob Select button.
b. Adjust the start time by turning the TIME soft knob. The
time cursors will move as delay is added to the start of the
effect.
c. “Re-delegate” M/E 1. Run the effect. Note that M/E 2
now starts later than M/E 1.