Tektronix Grass Valley 3000 - Manual (Page 64)

2-28
Section 2 — Startup & Configuration
Setting Switcher Output Timing
With the Effects Send option installed in a Model 3000, the PGM
output on Aux Buses 1 through 4 was delayed compared to other
switcher outputs. Software provides an adjustment of the
switcher length that allows you to match the timing of all outputs.
CAUTION
Adjustment of the switcher output timing is not recommended
unless you have the Effects Send option and you expect to use
PGM out on Aux Buses 1 through 4.
Increasing the switcher length may affect other timing in your
facility.
The switcher length timing adjustment is done in the
Configuration/Outputs/Output Timing menu.
1. To gain access to the switcher length adjustment, first press
the
CONFG button on the main menu subpanel, then press the
OUTPUTS> soft button in the Configuration menu.
OUTPUTS MENU
ON ON
config / outputs
CHROMA CLIP
= 105 %
LUM CLIP
= 105 IRE
ON
COMPOSITE CLIP
= 138 IRE
ON
PGM
M/E 1 PGM
M/E 2 PGM
AUX BUS 1
AUX BUS 2
AUX BUS 3
AUX BUS 4
AUX BUS 5
AUX BUS 6
AUX BUS 7
FRAMESTORE
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
-
-
-
-
-
-
-
-
-
- -
-
ON
OFF
OFF
OFF
-
-
-
-
BLACK CLIP
= -20 IRE
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF OFF OFF OFF
PGM OFF ON ON OFF
SUPER
BLACK OUTPUT
SELECT
SETUP
ON KEY UNSHAPER LIMITER
OUTPUT
TIMING >
DIGITAL
RES >