Sony DPP-EX50 - Manual (Page 115)

115 GB
Troubleshooting
Symptom
Printing stops
midway.
Connecting with a digital camera
Symptom
The PictBridge
mark does not
appear on the
LCD display of
the digital
camera.
Check
• Does the access indicator
light in green?
• Is the paper error ( )
indicator lit?
• Is any indicator lit?
Check
• Is the digital camera
connected correctly?
• Is the ON/STANDBY
button turned on?
• Does the firmware of your
digital camera support the
printer?
• Is the PictBridge mark on
the LCD display of the
printer flashing?
• Is printing in process?
Cause/Solutions
c The data size of an image is large and it
takes longer to process it for printing.
As soon as the data processing finishes,
the printer starts printing.
c Paper is jammed. See “If paper jams”
( .page 124) and remove jammed
paper from the printer. If jammed paper
cannot be removed, contact the Sony
service facilities.
c If no indicator is lit, the thermal head
may be overheated. Leave the printer
until the head cools down and the
printer resumes printing.
Cause/Solutions
c Connect the cable correctly.
c Turn on the ON/STANDBY button.
c See the homepage for the digital camera
you are using.
c The PictBridge mark is not displayed
while the printer is in the EDIT, Creative
Print, or other menu modes. Exit the
menu and then connect the cable again.
c If a USB mouse or other non-PictBridge-
compliant device is connected, remove it
and connect a PictBridge-compliant device.
c Disconnect the digital camera and the
printer and then connect them again. Or
turn off and then on the printer and the
digital camera.
c Connect the cable again after printing is
complete.