21 serial port peripherals, 3 register map – Texas Instruments TMS320F2802 User Manual
Page 39
,
,
,
SPRS230N – OCTOBER 2003 – REVISED MAY 2012
eQEP:
The enhanced QEP peripheral uses a 32-bit position counter, supports low-speed
measurement using capture unit and high-speed measurement using a 32-bit unit
timer.
This peripheral has a watchdog timer to detect motor stall and input error detection
logic to identify simultaneous edge transition in QEP signals.
ADC:
The ADC block is a 12-bit converter, single-ended, 16-channels. It contains two
sample-and-hold units for simultaneous sampling.
3.2.21 Serial Port Peripherals
The 280x devices support the following serial communication peripherals:
eCAN:
This is the enhanced version of the CAN peripheral. It supports 32 mailboxes, time
stamping of messages, and is CAN 2.0B-compliant.
SPI:
The SPI is a high-speed, synchronous serial I/O port that allows a serial bit stream of
programmed length (one to sixteen bits) to be shifted into and out of the device at a
programmable bit-transfer rate. Normally, the SPI is used for communications
between the DSP controller and external peripherals or another processor. Typical
applications include external I/O or peripheral expansion through devices such as
shift registers, display drivers, and ADCs. Multi-device communications are
supported by the master/slave operation of the SPI. On the 280x, the SPI contains a
16-level receive and transmit FIFO for reducing interrupt servicing overhead.
SCI:
The serial communications interface is a two-wire asynchronous serial port,
commonly known as UART. On the 280x, the SCI contains a 16-level receive and
transmit FIFO for reducing interrupt servicing overhead.
I2C:
The inter-integrated circuit (I2C) module provides an interface between a DSP and
other devices compliant with Philips Semiconductors Inter-IC bus (I2C-bus)
specification version 2.1 and connected by way of an I2C-bus. External components
attached to this 2-wire serial bus can transmit/receive up to 8-bit data to/from the
DSP through the I2C module. On the 280x, the I2C contains a 16-level receive and
transmit FIFO for reducing interrupt servicing overhead.
3.3
Register Map
The 280x devices contain three peripheral register spaces. The spaces are categorized as follows:
Peripheral
These are peripherals that are mapped directly to the CPU memory bus.
Frame 0:
See
.
Peripheral
These are peripherals that are mapped to the 32-bit peripheral bus.
Frame 1
See
.
Peripheral
These are peripherals that are mapped to the 16-bit peripheral bus.
Frame 2:
See
Copyright © 2003–2012, Texas Instruments Incorporated
Functional Overview
39
Product Folder Link(s):