TANDBERG 1D13898.07 - Manual (Page 14)

14
D13898.07
NOVEMBER 2008
TANDBERG CONTENT SERVER
ADMINISTRATOR GUIDE
Table of
Contents
Introduction Installation Quick Setup
TCS
Administration
Backing up and
Restoring
Administrator
Settings
Conference
Setup
View
Conferences
Appendices

Connect the AC power
cable to an electrical distribution
socket. Press the power switch
button at the back side to
1 to
turn on the Content Server.
On the front panel of the system
the power indicator LED, marked
Pwr , will light up.
Preparing for Use
What’s in the Box?
To avoid damage to the unit during transportation,
the Content Server is delivered in a special
shipping box, which should contain the following
components:
CD with User Guide and other documentation. •
Rack-ears and screws. •
Power cable. •
Ethernet cable. •
TANDBERG Content Server. •
Please report any discrepancies to your
TANDBERG Representative immediately.
Installation Site Preparations
Make sure the Content Server is accessible •
and that all cables can be easily connected.
For ventilation: Leave a space of at least
•
10 cm (4 inches) behind the Content
Server’s rear panel and 10 cm (4 inches) in
front of the front panel.
The room in which you install the Content
•
Server should have an ambient temperature
between 0 ºC and 35 ºC (32 ºF and 95 ºF)
and between 10 % and 90 % non-condensing
relative humidity.
Do not place heavy objects directly on top of
•
the Content Server.
Do not place hot objects directly on top, or
•
directly beneath the Content Server.
Use a grounded AC power outlet for the
•
Content Server.
Rack Mounting (optional)

Before starting the rack mounting please
make sure the TANDBERG Content Server
is placed securely on a hard flat surface.

Disconnect the AC power cable, if
applicable.

Make sure that the mounting space is
prepared according to the
Installation Site
Preparations below left.

Attach the brackets to the Content Server
on both sides of the unit.

Insert the Content Server into a 19” rack, and secure with screws in the front (four screws).

Connect a LAN cable from
the
LAN 1 connector
on the Content Server
to your network.
The
LAN 2 , 3 and 4
connectors are
not used and should
be left open.
Connecting Cables
10 cm
10 cm