TANDBERG D12155-10 - Manual (Page 111)

TANDBERG Videoconferencing System
111
Appendices
Streaming password
By setting a streaming password in the streaming menu on the TANDBERG codec, a password have to be entered on
the streaming client to be able to see the videostream from the TANDBERG Videoconferencing Unit.
IP Password
By setting a IP Password on the TANDBERG codec, all access to the system using IP (Telnet, FTP, WEB) requires a
password. This password can be enabled from telnet or dataport using the command: ippassword <ip-password>. The
default IP password is ‘TANDBERG’.
To remove this password, use the command: ippassword ””. From telnet, this is only possible by first entering the
correct password.
Services
The different IP services on the TANDBERG codec - FTP, Telnet, HTTP, SNMP and H.323 can be disabled to prevent
access to the system. By using the commands below, the services can be independently enabled/disabled:
services <telnet/ftp/http/h323/remote-software> <enable/disable>
services <snmp> <read-only/enable/disable>
services <telnetchallenge> <enable/disable> [port]
SNMP Security alert
This function will notify any Management Application (such as TMS - TANDBERG Management Suite) if anyone tries to
perform Remote Management on the TANDBERG Codec using a illegal password. The Security alert that is sent to the
Management Application will contain information about the IP address and the service (WEB, Telnet, FTP) being used
for the attempt.
If TMS is used, email notifications or alarms about the attempt can be sent to specified persons.