Texas Instruments TITANIUM TI-89 - Manual (Page 401)

3D Graphing 401
Drawing Contours for Specified Z Values Drawing Contours for Specified Z Values Drawing Contours for Specified Z Values Drawing Contours for Specified Z Values
From the Graph screen, display the Draw menu and then select 8:DrwCtour . The Home
screen is displayed automatically with DrwCtour in the entry line. You can then specify
one or more z values individually or generate a sequence of z values.
Some examples are:
Note: To remove the default contours, use 8 $ and set
ncontour=0 .
The specified contours are drawn on the current 3D graph. (A contour is not drawn if the
specified z value is outside the viewing cube or if the 3D graph is not defined at that z
value.)
Notes about Contour Plots Notes about Contour Plots Notes about Contour Plots Notes about Contour Plots
For a contour plot:
• You can use the cursor keys to animate the contour plot.
• You cannot trace ( …) the contours themselves. However, you can trace the wire
frame as seen when Style=WIRE AND CONTOUR.
• It may take awhile to evaluate the equation initially.
DrwCtour 5 Draws a contour for z=5.
DrwCtour {1,2,3} Draws contours for z=1, 2, and 3.
DrwCtour
seq(n,n,
L 10,10,2)
Draws contours for a sequence of z values
from
L 10 through 10 in steps of 2 ( L 10, L 8, L 6,
etc.).