Texas Instruments TITANIUM TI-89 - Manual (Page 454)

Tables 454
Tables Tables Tables Tables
Overview of Steps in Generating a Table Overview of Steps in Generating a Table Overview of Steps in Generating a Table Overview of Steps in Generating a Table
To generate a table of values for one or more functions, use the general steps shown
below. For specific information about setting table parameters and displaying the table,
refer to the following pages.
Generating a Table Generating a Table Generating a Table Generating a Table
1. Set Graph mode and, if necessary, Angle
mode ( 3).
Note: Tables are not available in 3D Graph
mode.
2. Define functions on Y= Editor ( 8 #).
3. Select ( †) which defined functions to
display in the table.
Note: For information on defining and
selecting functions with the Y= Editor,
refer to Basic Function Graphing.
4. Set up the initial table parameters
( 8 &).
Note: You can specify an automatic table
that is based on initial values or that
matches a graph, or a manual (ask) table.