Texas Instruments TITANIUM TI-89 - Manual (Page 607)

Programming 607
If Command If Command If Command If Command
To execute only one command if a conditional test is true, use the general form:
Ê
Executed only if x>5; otherwise, skipped.
Ë
Always displays the value of x.
In this example, you must store a value to x before executing the If command.
Note: Use indentation to make your programs easier to read and understand.
If...Then...EndIf Structures If...Then...EndIf Structures If...Then...EndIf Structures If...Then...EndIf Structures
To execute one group of commands if a conditional test is true, use the structure:
Ê
Executed only if x>5.
Ë
Displays value of:
• 2x if x>5
• x if x
{ 5
К
Л
:If x>5
: Disp "x is greater than 5"
:Disp x
К
К
Л
:If x>5 Then
: Disp "x is greater than 5"
: 2
†
x
!
x
:EndIf
:Disp x