Technicolor - Thomson VMD 22 - Manual (Page 17)

16
EN
180 °
90
°
2 5
90 min 89 min 3 min
2 min 1 min 0 min
min
BR I GHT
RECORDING Basic Recording For Video
POWER Lamp
Tally lamp
(lights while
recording is
in progress)
MODE Dial
START/STOP Button
Tape remaining
time indicator
(Approximate)
(Now calculating)
(Blinking) (Blinking) (Blinking)
Display
To Adjust The Brightness Of The Display
.... rotate the MENU wheel until the bright level indicator
on the display moves and the appropriate brightness is
reached.
•It is also possible to adjust the brightness of the viewfinder.
POWER Switch
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
● Power (
੬
pg. 6)
● Grip Adjustment (
੬
pg. 8)
● Viewfinder Adjustment (
੬
pg. 8)
● Load A Cassette (
੬
pg. 10)
● Recording Mode Setting (
੬
pg. 11)
1 Set the MODE Dial to “VIDEO” and set the POWER
Switch to “
” while pressing down the Lock
Button located on the switch.
Shooting while using the viewfinder: Make sure the
LCD monitor is closed and locked. Pull out the
viewfinder fully.
•Be sure to pull out the viewfinder until you hear a
click, otherwise it may be pushed back in during
use.
Shooting while using the LCD monitor: Make sure
the viewfinder is pushed back in. Open the LCD
monitor fully.
•The POWER lamp lights and the camcorder enters
the Record-Standby mode. “PAUSE” is displayed.
2 Press START/STOP. “ ” appears while recording is
in progress.
To Stop Recording . . .
.... press START/STOP. The camcorder re-enters the
Record-Standby mode.
MENU Wheel
Lock Button
VMD22 EN(02/33) 29/08/00, 14:40 16