Technicolor - Thomson VMD 22 - Manual (Page 9)

8
EN
PAUSE
Grip Adjustment
1 Separate the Velcro strip.
2 Pass your right hand through the loop and grasp
the grip.
3 Adjust so that your thumb and fingers can easily
operate the START/STOP Button and Power
Zoom Lever. Refasten the Velcro strip.
Viewfinder Adjustment
1 Set the POWER Switch to “ ” while
pressing down the Lock Button located on the
switch and set the MODE Dial to any position.
2 Pull out the viewfinder fully.
3 Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
START/STOP Button
Power Zoom Lever
Dioptre Adjustment Control
POWER Switch
GETTING STARTED (cont.)
MODE Dial
CAUTION:
When using a tripod, be sure to open and
extend its legs fully to stabilise the
camcorder. To prevent damage to the unit
caused by falling over, do not use a small-
sized tripod.
Tripod Mounting
1 Align the screw on the tripod with the camera’s
mounting socket. Then tighten the screw.
Lock Button
VMD22 EN(02/33) 29/08/00, 14:40 8