Technicolor - Thomson VMD 22 - Manual (Page 92)

EN
91
Indications Function
Displays the battery remaining power.
Remaining power level: high
Remaining power level: exhausted
As the battery power comes close to nil, the battery indicator
blinks.
When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded. (
੬
pg. 10)
Appears when the erase protection tab is set to “SAVE” while the POWER
Switch is set to “
”. (
੬
pg. 10)
Appears if dirt is detected on the heads during recording. Use an optional
cleaning cassette.
(
੬
pg. 94)
Appears if condensation occurs. When this indication is displayed, wait
more than 1 hour until condensation disappears.
Appears if a tape is not loaded when START/STOP is pressed while the
POWER Switch is set to “
” and the MODE Dial is set to “VIDEO”,
“ ” or “ DUAL ”.
Appears when the tape ends during recording or playback. (
੬
pg. 17)
Appears if a tape in another format is loaded.
● Appears when the date/time is not set. (
੬
pg. 9)
● Appears when the built-in clock (lithium) battery is discharged and the
previously set date/time is erased. (
੬
pg. 9)
Appears if Audio Dubbing is attempted on a blank portion of a tape.
(
੬
pg. 76)
● Appears if Audio Dubbing is attempted on a tape recorded in the LP
mode. (
੬
pg. 76)
● Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
audio. (
੬
pg. 76)
● Appears if A. DUB (e) on the remote control is pressed when the erase
protection tab is set to “SAVE”. (
੬
pg. 76)
Appears when the MultiMediaCard’s memory is full and shooting is not
possible.
Warning Indications
TAPE!
TAPE END
SET DATE/TIME!
MEMORY IS FULL
CHECK TAPE’S ERASE
PROTECTION SWITCH
HEAD CLEANING
REQUIRED USE
CLEANING CASSETTE
CONDENSATION
OPERATION PAUSED
PLEASE WAIT
DIFFERENT
FORMATTED TAPE
A. DUB ERROR!
<CANNOT DUB
ON A LP RECORDED
TAPE>
<CANNOT DUB
ON A 16BIT
RECORDING>
<CHECK TAPE’S ERASE
PROTECTION SWITCH>
A. DUB ERROR!
CONTINUED ON NEXT PAGE
VMD22 EN(66/100) 29/08/00, 15:48 91