Technicolor - Thomson VMD 22 - Manual (Page 65)

64
EN
T
P O
US C
H OP
"
Y
SN T
A
O
PS
T
H
A
O P
T E
"
POWER Switch
Rewind Button (2)
Fast-Forward Button (3)
Dubbing Images Stored In A
MultiMediaCard To A Tape
Images can be dubbed from a MultiMediaCard to a tape.
1 Load a MultiMediaCard (
੬
pg. 12) and cassette
(
੬
pg. 10).
2 Set the POWER Switch to “ ” while pressing
down the Lock Button located on the switch. Open
the LCD monitor fully or pull out the viewfinder fully.
3
2
To locate the point where you wish to dub a still
image, play back the tape. Stop playback at the
desired point.
4
3
Set the POWER Switch to “ MEMORY
PLAY
” while pressing
down the Lock Button located on the switch. To
select a still image to be dubbed, perform Index
Playback (
੬
pg. 47), Auto Playback (
੬
pg. 45) or
press 2 or 3 to select the image you wish.
5 To engage Dub-Standby, press SNAPSHOT. The
message “TO COPY TO TAPE PUSH "SNAPSHOT"”
appears.
6 While the message is being displayed, press
SNAPSHOT again. The selected still image is
recorded on the tape for approx. 6 seconds.
•The
indicator disappears when dubbing is
complete.
NOTES:
● If SNAPSHOT is pressed in step 5 when the tape’s erase
protection tab is set to “SAVE”, the message “COPYING
FAILED” is displayed.
● The XGA image is dubbed onto the tape at 720 x 480
pixels.
● You can superimpose a snap frame over the selected still
image to be dubbed (
੬
pg. 51) and dub it to a tape.
After step 4, superimpose a snap frame over the still
image and go to step 5.
Display
DUBBING (cont.)
SNAPSHOT Button
Lock Button
VMD22 EN(34/65) 29/08/00, 15:16 64