Technicolor - Thomson VMD 22 - Manual (Page 64)

E N
6 3
DV cable
(optional)
Video unit equipped
with DV connector
To DV OUT
To DV IN/OUT
POWER Switch
Core filter
Core filter
Lock Button
Open the
connector cover.
Dubbing From A Video Unit Equipped With
A DV Connector (Digital Dubbing)
[To use this camcorder as a recorder]
NOTE:
Before the following steps, make sure that “AV/S-VIDEO”
is set to “OUT” in the Menu Screen (
੬
pg. 41).
1 Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV output
connector using a DV cable as shown in the
illustration.
2 Set “REC MODE” to “SP” or “LP” in the Menu Screen
depending on your preference (
੬
pg. 11).
3 Set this camcorder’s POWER Switch to “ ”
while pressing down the Lock Button located on the
switch. Turn on the video unit’s power and insert the
appropriate cassettes in the camcorder and the video
unit.
4 Press START/STOP on the camcorder to engage the
Record-Pause mode.
“DV. IN” appears on the screen.
5 Engage the video unit’s Play mode, then engage the
Still Playback mode when you have found a spot just
before the edit-in point.
6 Press START/STOP on the camcorder to engage the
Record mode. “
DV. IN ” appears on the screen.
Engage the video unit’s Play mode.
7 To stop dubbing, press START/STOP on the
camcorder so that “DV. IN” reappears, then engage
the video unit’s Stop mode.
8 Repeat steps 5 through 7 for additional editing.
NOTES:
● It is recommended to use the AC Power Adapter/ Charger as the power supply instead of the battery pack
(
੬
pg. 7).
● If the remote control is used when both the player and recorder are THOMSON video units, both units will
perform the same operation. To prevent this from happening, press the buttons on both units.
● For Digital Dubbing, this camcorder can be connected only to one device at a time.
● If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so
that an unusual image is not dubbed.
● Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this
occurs, turn off the power and make connections again.
● When using a DV cable, be sure it has a core filter attached. The core filter reduces interference.
● Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
“SOUND MODE” setting (
੬
pg. 27).
● During Digital Dubbing, no signals are output from the video or audio connectors.
VMD22 EN(34/65) 29/08/00, 15:16 63