TOYOTA EPS9000 - Manual (Page 15)

PREP
ARAT
IO
N
15
CARRYING
As shown in the illustration below, hold the machine at the positions indicated in the label by two or more per-
sons to carry the machine.
INSTALLATION
Place the embroidery machine on a rugged base so that the table will be level.
At this time, make sure to place attached vibration-preventive rubbers (H)
under the adjuster foot (1). The rubbers will effectively prevent the machine
from moving on the table or vibrating.
If the machine is not stable or it is not level, adjust the level of
the machine after loosening the nut (2) (4 places) of the adjuster
foot (1). After adjusting the machine level, tighten the nut (2) to
lock the adjuster foot.
Machine holding position
(indicated in the label) Machine holding position
(indicated in the label)
WARNING !
CARRYING
Carry the machine with
at least two people.
DO NOT hold it by parts
other than those specified.
Dropping may cause bodily
injury and will damage
the machine. Il faut être au moins 2personnes
pour porter la machine.
Ne pas tenir la machine par
une autre partie que celle
indiquées.
Une chute peut vous blesser
et endommager la machine.
ATTENTION !
Nut (2)
Adjuster foot (1)
Base (must be level)
Table top face
Vibration-preventive rubber (H)
Vibration-preventive rubber (H)