TOYOTA EPS9000 - Manual (Page 85)

OPERAT
ION
PROCED
URE
85
TRACE
This function makes the hoop travel along the rectangle that surrounds the
embroidery range of the design data that has been set as the embroidery data.
Tracing will start from the design start point and move to the rear right, rear left,
front left and front right corners of the embroidery range, then return to the
design start point.
If repeat is set, the function traces the entire embroidery range.
If the TRACE key is pressed during tracing, tracing stops at the nearest corner
in the trace advancing direction.
Tracing restarts when the TRACE key is pressed again.
It is possible to stop tracing at each corner by repeating this.
If "Mirror: Y" is set, trace is made in the manner as shown below.
Design
start point
FD07