TOYOTA EPS9000 - Manual (Page 64)

OP
ERAT
ION
PROCED
URE
64
DATA INPUT (PC)
The following explains the procedure for inputting the design data from an
external device connected to the serial port to the machine (PC). The input
data is set as the embroidery data.
1 Connect the external device to the serial port of the machine.
Before connecting an external
device (PC) to the machine (serial
port), turn OFF the power supply to
the external device and the
machine.
Use the special cable (to be pur-
chased separately) for connecting
an external device (PC) to the
serial port of the machine.
2 Turn ON the power switch of the machine.
3 After making sure that the power is supplied to the machine, turn ON
the power switch of the external device.
4 Send the design data from the external device.
5 Change the display to DATA MENU.
6 Select "PC" for "1. INPUT DATA".
7 Read the data from the external device.
FD07
To the external device (PC)
Serial port
Embroidery machine
Power supply box
* * * * * E M B S T A R T * * * * *
A I S I N 1 2 3 . 1 0 O 1
0 / 1 0 2 7
0 1 / 9 9 : 2 3 - 5 6 7 8 9 A B < D >
1
Press .
Select "PC" using the following keys:
and (hoop travel keys)
* * * * * D A T A M E N U * * * *
1 . I N P U T D A T A 3 3 5
2 . S E L E C T D A T A
3 . D E L E T E D A T A
* * * * * D A T A M E N U * * * *
1 . I N P U T D A T A P C
2 . S E L E C T D A T A
3 . D E L E T E D A T A
Press .