Texas Instruments TMS320DM357 - Manual (Page 139)

4.81 Transmit Endpoint FIFO Address (TXFIFOADDR)
4.82 Receive Endpoint FIFO Address (RXFIFOADDR)
www.ti.com Registers
Section 2.5 describes dynamically setting endpoint FIFO sizes.
The Transmit Endpoint FIFO Address (TXFIFOADDR) is shown in Figure 96 and described in Table 97 .
Figure 96. Transmit Endpoint FIFO Address (TXFIFOADDR)
15 13 12 0
Reserved ADDR
R-0 R/W-0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 97. Transmit Endpoint FIFO Address (TXFIFOADDR) Field Descriptions
Bit Field Value Description
15-13 Reserved 0 Reserved
12-0 ADDR 0-1FFFh Start Address of endpoint FIFO in units of 8 bytes
If m = ADDR[12:0] then the start address is 8*m
Section 2.5 describes dynamically setting endpoint FIFO sizes.
The Receive Endpoint FIFO Address (RXFIFOADDR) is shown in Figure 97 and described in Table 98 .
Figure 97. Receive Endpoint FIFO Address (RXFIFOADDR)
15 13 12 0
Reserved ADDR
R-0 R/W-0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 98. Receive Endpoint FIFO Address (RXFIFOADDR) Field Descriptions
Bit Field Value Description
15-13 Reserved 0 Reserved
12-0 ADDR 0-1FFFh Start Address of endpoint FIFO in units of 8 bytes
If m = ADDR[12:0], then the start address is 8*m
SPRUGH3 – November 2008 Universal Serial Bus (USB) Controller 139
Submit Documentation Feedback