TP-Link TL-R4000 - Manual (Page 24)

TL-R4000 Enterprise Broadband Router User Guide
18
)
Note:
1) Only the PC(s) on your LAN can use the MAC Address Clone feature.
2) If you click the Save button, the router will prompt you to reboot.
4.4.4 Bandwidth Control
You can control bandwidth of each LAN port on this page. This feature can be used for
distributing flexibly Internet resource.
Figure 4-11 Bandwidth Control
¾
LAN - LAN port number. LAN1 point to LAN port 1, LAN2 point to LAN port 2, and
so on.
¾ Bandwidth - Select the bandwidth value from 128Kbps, 256Kbps, 512Kbps,
1Mbps, 2Mbps, 4Mbps and 8Mbps. The selected value is the maximum Internet
bandwidth for the LAN port. No-limit means no bandwidth limit.
4.4.5 VLAN
On this page, you can configure VLAN based on LAN port. There are three VLAN
modes in the VLAN Mode pull-down list: One VLAN, Two VLAN and Four VLAN, the
default is One VLAN.
Figure 4-12 VLAN Settings
¾
One VLAN - In this VLAN mode, all LAN ports are in one VLAN, all LAN ports can
communicate with each other.
¾
Two VLANs - In this VLAN mode, the LAN1 and LAN2 are in one VLAN, and the
LAN3 and LAN4 are in another VLAN. So LAN1 can communicate with LAN2 and
LAN3 can communicate with LAN4, but LAN1 or LAN2 cannot communicate with
LAN3 or LAN4.
¾
Four VLANs - In this VLAN mode, all ports are in different VLANs. So they cannot
communicate with each other.