TP-Link TL-R4000 - Manual (Page 30)

TL-R4000 Enterprise Broadband Router User Guide
24
Figure 4-21 Add or Modify a Virtual Server Entry
¾
Common Service Port - Some common services already listed in the pull-down
list.
To setup a virtual server entry:
1. Click
the Add New.. button.
2. Select the service you want to use from the Common Service Port list, If the
Common Service Port list does not have the service that you want to use, enter
the number of the service port or service port range in the Service Port box.
3. Enter the IP address of the computer in the Server IP Address box.
4. Select the protocol used for this application, either TCP, UDP, or All.
5. Select
the Enable in the Status pull-down list .
6. Click the Save button.
)
Note:
It is possible that you have a computer or server that has more than one type of
available service. If so, select another service, and enter the same IP address for that
computer or server.
To modify or delete an existing entry:
1. Find the desired entry in the table.
2. Click
Modify or Delete as desired on the Modify column.
Click the Enable All button to make all the entries enabled.
Click the Disable All button to make all the entries disabled.
Click the Delete All button to delete all the entries.