Uniden NEO TRUC56 - Manual (Page 13)

GETTING ST
ARTED
G E T T I N G S TA R T E D [ 11 ]
B. Install the battery pack
Charge the battery pack for at least 3-5 hours before
plugging the phone line into your base unit.
1) Press down on the latch and lift the battery cover.
2) Connect the battery pack connector observing the correct
polarity (black and red wires) to the jack inside the
battery compartment.
Do not exert any force on this connection. It could cause
damage to the battery or to the handset. The plastic
connectors will fit together in only one way. Make sure
that you have made a good connection.
3) Align the left side of the battery and insert the battery
as shown.
4) Insert the tabs of the cover into the slots of the
battery compartment and securely close the cover
by pressing down.
5) Place the handset in the base with the keypad facing
forward.
6) Slide the handset down until it clicks.
RED
BLACK
BLACK
noir
RED
rouge
1 2
• Use only the Uniden
battery (BT-925)
supplied with your
phone. Replacement
batteries are also
available through
the Uniden Parts
Department.
(See page 9.)
• Recharge your phone on
a regular basis by
returning the handset to
the base after each
phone call.
TRUC56_OM 12/11/02 9:24 AM Page 11