Uniden NEO TRUC56 - Manual (Page 46)

A D D I T I O N A L I N F O R M AT I O N [ 44 ]
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code, deregister the code, then
register a different code.
De-register the Security Code
1) Remove the handset from the base. In the standby mode, press and hold
DEL/TRANS (xfer/del for TXC400) and END until you hear a confirmation tone.
“ De-Register? ” appears.
2) Press UP to select “ Yes ”, then SELECT/CH . You will hear a confirmation tone,
and “ Deregistration Complete ” appears.
Changing the Digital Security Code
• If you have not pressed any key for 30 seconds while in the de-registering operation, the
phone returns to the standby mode.
• While in de-registering operation, if you receive an incoming call, page, or transferring call, or
charge the handset, or press TALK/FLASH or END , the operation is canceled.
TRUC56_OM 12/11/02 9:26 AM Page 44