Uniden NEO TRUC56 - Manual (Page 47)

ADDITIONAL
INFORMA
TION
A D D I T I O N A L I N F O R M AT I O N [ 45 ]
Register the Security Code
1) Unplug the AC adapter.
2) Press and hold
PAGE on the base, while you plug in the AC Adapter, hold PAGE
until the status LED on the base flashes.
3) Press TALK/FLASH . “ Handset Registering ” appears.
When the registration operation is finished “ Registration Complete ”
appears and the status LED is no longer illuminated. You will hear a
confirmation tone and the phone returns to the standby mode.
• You must complete the registration operation within 30 seconds, or the phone returns to the
standby mode.
• During the registration operation, you cannot receive an incoming call, page, or make a call.
Installing the Holster
• Line up the groove on the back of the handset with the groove
on the holster. It fits in the holster only one way.
• Slide the phone into the holster.
• Use the spring clip to attach the holster to your belt or pocket. When you charge the
handset, remove the
holster if it is attached.
If you have a second handset (TXC400)
You need to perform the following steps:
1) De-register the digital security code of the TXC400 by following the steps on page 44.
2) Register the TXC400 to the TRUc56 base (For instructions, see “Registering the Second
Handset” on page 41).
TRUC56_OM 12/11/02 9:26 AM Page 45