Uniden NEO TRUC56 - Manual (Page 7)

Q U I C K R E F E R E N C E G U I D E [ 5 ]
Q
UICK
R
EFERENCE
G
UIDE
INSTALL THE HANDSET BATTERY
Remove the cover.
Connect the battery
pack connector
with the
correct polarity.
Insert the battery
pack into the
battery compartment.
Replace the cover.
PLUG INTO AC POWER
Plug the AC adapter cord into
the base unit and then to a
120V AC outlet.
Place the handset in the base.
Note:
You must charge the battery pack
continuously for 3-5 hours before
using the phone.
Step 1 Charging the Battery Step 2 Connecting Step 4 Installing the Headset
Step 3 Setting up the Caller
ID Options/Language
CONNECT TO A PHONE LINE
When the handset battery pack is fully
charged, plug the telephone cord into
the base unit and then into a telephone
wall jack.
Your phone is set for tone dialing. If your
local network requires pulse dialing, please
see “Setting up the phone, Choose the
dialing mode” in your owner’s manual.
RED
BLACK
BLACK noir RED rouge
1 2
Note : Three Caller ID options
are available: Auto Talk, Caller
ID on Call Waiting (CIDCW) and
Area Code.
To make or receive a call, you must install
the headset.
Wear the headset.
Plug the headset cord into the jack
on the top of the handset.
TO SELECT CALLER ID OPTIONS
Press MENU/MUTE .
Press UP or DOWN to move the
pointer to “ Caller ID
Setup ”, then press SELECT/CH .
Press UP or DOWN to move the
pointer to an option, then
press
SELECT/CH .
Press UP or DOWN to change the
option setting.
Press SELECT/CH and return the
handset to the base.
TO CHOOSE THE LANGUAGE
Press MENU/MUTE .
Press UP or DOWN to move the
pointer to “ Language ”,
then press SELECT/CH .
Press UP or DOWN to change the
option setting.
Press SELECT/CH and return the
handset to the base.
TRUC56_OM 12/11/02 9:24 AM Page 5