Vivotek NETWORK CAMERA IZ7151 - Manual (Page 28)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
 - User's Manual
If the default ports are already used by other device connecting to the same router, the Network
Camera will select other ports for the Network Camera�
If UPnP TM is not supported by your router, you will see the following message�
PPPoE
Select this option to configure your Network Camera to make it accessible from anywhere as long
as there is an Internet connection� Note that to utilize this feature, it requires an account provided
by your ISP� Follow the steps below to acquire your Network Camera's public IP address�
1
: Set up the Network Camera in a local area network�
2
:
Go to Configuration > Application > Server Settings (see Server Settings on page 58) to
add a new server -- email or FTP server�
3
:
Go to Configuration > Application > Media Settings (see Media Settings on page 56)� Select
System log so that you will receive a list of system log in TXT file format which contains the
Network Camera's public IP address in your email or on the FTP server�
4
:
Go to Configuration > Network > Network Type. Select PPPoE and enter the user name
and password provided by your ISP� Click Save to take effect�
5
: The Network Camera starts to reboot�
6
: Disconnect the power source of the Network Camera; remove it from the local area network
environment to the Internet�
NOTE :
► Steps to enable UPnP TM user interface on your computer:
Note that you must log on to the computer as a system administrator to install the UPnP TM
components
1
: Go to Start, click Control Panel, and then click Add or Remove Programs�