Vivotek NETWORK CAMERA IZ7151 - Manual (Page 6)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
 - User's Manual
Hardware Reset
Mic
RESET
Ethernet
Ext. Int. Audio Out
1 2 3 4 5 6 7 8
RESET
1 2 3 4 5 6 7 8
There is an indented reset button on the back panel of the Network Camera� It is used to reboot
the Network Camera or restore the Network Camera to factory default� Sometimes rebooting the
Network Camera sets the Network Camera back to normal state� If the problems remain after
rebooting, restore the factory default and install again�
Reboot : Press and release the indented reset button with a needle� Wait for the Network Camera
to reboot�
Restore : Press the indented reset button continuously for around 30 seconds until the status LED
rapidly blinks red and green simultaneously� Note that all settings will be restored to factory default�