Wolf Appliance Company SO30F/S - Manual (Page 37)

W O L F E L E C T R I C C O O K T O P S
37
P L A N N I N G I N F O R M A T I O N
From a planning perspective, your selection
process is made easier by the three different
sizes you have to choose from. The 30" (762)
and 36" (914) framed electric cooktops are avail-
able in three trim finishes—classic, platinum and
carbon stainless steel. The 15" (381) cooktop is
available with classic stainless steel trim only.
For ease of installation, Wolf recommends using
33" (838) cabinets with the 30" (762) cooktop
and 39" (991) cabinets with the 36" (914)
cooktop.
Specifications on the following pages provide
overall dimensions, countertop cut-out dimen-
sions and installation specifics for the three
different-sized cooktops. We have minimized
the information contained in the illustrations,
concentrating on the critical information you
need to plan your installation.
A Wolf L Series or E Series built-in single oven
may be installed below these cooktops. Wolf
framed electric cooktops are designed and
agency approved for installation with Wolf built-
in ovens only. Also, be aware of the depth of the
cooktop when planning for this installation.
Multiple cooktops and/or integrated modules
can be installed side by side. Refer to the coun-
tertop cut-out dimensions on page 55 when
planning for this installation.
These cooktops can accommodate a Wolf
cooktop hood, downdraft system or Pro ventila-
tion hood or hood liner. When installing a ventila-
tion hood, refer to the specific requirements of
the hood for the minimum dimension to the
countertop. Refer to pages 92–114 for ventilation
specifications.
E L E C T R I C A L R E Q U I R E M E N T S
The electrical requirements vary with the size
of the framed electric cooktop. Refer to the
specifications on the following pages for the
three different cooktop sizes. Locate electrical
supply within the shaded area shown in the
Installation Specifications illustration for your
model.
IMPORTANT NOTE: When an oven is installed
below the cooktop, it is recommended that the
electrical supply be placed in the base cabinet to
the right of the oven, unless you are using
cabinets deeper than 24" (610). Refer to pages
4–14 for additional specifications for built-in
ovens.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
These cooktops are intended for indoor use.
This appliance must be installed in accordance with
National Electrical Code regulations as well as all
state, municipal and local codes. The correct
voltage, frequency and amperage must be supplied
to the appliance from a dedicated, grounded circuit
that is protected by a properly sized circuit breaker
or time delay fuse. The proper voltage, frequency
and amperage ratings are listed on the product
rating plate.
A C C E S S O R I E S
Optional accessories
are available
through your Wolf
dealer. To obtain
local dealer
information, visit
the Showroom
Locator section of
our website,
wolfappliance.com.
A C C E S S O R I E S
Electric Cooktops
Filler strip
Bracket supports for installation
of two integrated modules with
downdraft (Model DD30 only)
Accessories are available through
your Wolf dealer. To obtain local
dealer information, visit the
Showroom Locator section of our
website, wolfappliance.com.