Wolf Appliance Company SO30F/S - Manual (Page 45)

W O L F E L E C T R I C C O O K T O P S
45
IMPORTANT NOTE: A Wolf downdraft ventila-
tion system cannot be used with the unframed
electric cooktops.
IMPORTANT NOTE: Unframed electric cooktops
are not designed to be installed in combination
with other cooktops or modules.
E L E C T R I C A L R E Q U I R E M E N T S
The electrical requirements vary with the size
of the unframed electric cooktop. Refer to the
specifications on the following pages for the
two different cooktop sizes. Locate electrical
supply within the shaded area shown in the
Installation Specifications illustration for your
model.
IMPORTANT NOTE: When an oven is installed
below the cooktop, it is recommended that the
electrical supply be placed in the base cabinet to
the right of the oven, unless you are using
cabinets deeper than 24" (610). Refer to pages
4–14 for additional specifications for built-in
ovens.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
P L A N N I N G I N F O R M A T I O N
Wolf recommends using 33" (838) cabinets
with the 30" (762) cooktop and 39" (991)
cabinets with the 36" (914) cooktop.
The Wolf 30" (762) and 36" (914) unframed
electric cooktops can be mounted flush with the
top of the countertop or as a frameless installa-
tion sitting on top of the countertop surface.
There’s no stainless steel trim, just the black
ceramic glass surface. In either installation the
cooktop cut-out dimensions are the same. If the
cooktop is to be mounted flush with the coun-
tertop, you will need to provide a recessed area
surrounding the cooktop cut-out.
IMPORTANT NOTE: If the cooktop is to be
mounted flush with the countertop, fabrication
of the recessed area must take place before the
final countertop installation. A template of the
countertop cut-out will be provided with the
cooktop for fabrication purposes.
Specifications on the following pages provide
overall dimensions, countertop cut-out dimen-
sions and installation specifics for the two
different-sized cooktops. We have minimized
the information contained in the illustrations,
concentrating on the critical information you
need to plan your installation.
A Wolf L Series or E Series built-in single oven
may be installed below these cooktops. Wolf
unframed electric cooktops are designed and
agency approved for installation with Wolf built-
in ovens only. Also, be aware of the depth of the
cooktop when planning for this installation.
A Wolf cooktop or Pro ventilation hood is
recommended with these cooktops. When
installing a ventilation hood, refer to the specific
requirements of the hood for the minimum
dimension to the countertop. Refer to pages
92–114 for ventilation specifications.
These cooktops are intended for indoor use.
This appliance must be installed in accordance
with National Electrical Code regulations as well
as all state, municipal and local codes. The
correct voltage, frequency and amperage must
be supplied to the appliance from a dedicated,
grounded circuit that is protected by a properly
sized circuit breaker or time delay fuse. The
proper voltage, frequency and amperage ratings
are listed on the product rating plate.
A C C E S S O R I E S
Optional accessories
are available
through your Wolf
dealer. To obtain
local dealer
information, visit
the Showroom
Locator section of
our website,
wolfappliance.com.