Warning, Winding springs continued, Drum wrap installation – Wayne-Dalton TORQUEMASTER 46 User Manual

Page 26

Advertising
background image

26

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the

Find a Dealer section online at www.wayne-dalton.com

Tools Needed:

onto the left hand winding shaft end. To

wind the spring, rotate the winding shaft

clockwise, while watching the mark on the

winding shaft.

Rotate the winding shaft to the required

number of turns for your door. Then return

to the right hand side and wind the right

hand spring to the required number of

turns. Place pawl knob in lower position on

both sides.

IMPORTANT: MARk NuMBER Of SPRING

TuRNS ON TORquEMASTER

®

PLuS END

BRACkET WARNING TAG.

NOTE: Since total turns to balance door

can deviate from SPRING TuRN ChART

values by ± 1/2 turn, adjustments to the

recommended number of turns may be

required AfTER the rear hanger assembly

is completed.

IMPORTANT:

hOLD ThE DOOR DOWN TO

PREVENT IT fROM RAISING

uNEXPECTEDLy, IN ThE EVENT ThE

SPRING WAS OVERWOuND AND

CAuTIOuSLy REMOVE VICE CLAMPS fROM

VERTICAL TRACkS.

Do not raise the door until horizontal

tracks are secured at the rear, as outlined

in step 27.

RAISING DOOR fuRThER CAN

RESuLT IN DOOR fALLING AND

CAuSE SEVERE OR fATAL INjuRy.

Spring Turns

Door Height

Spring Turns

(6’ - 0”)

14

(6’ - 3”)

14 - 1/2

(6’ - 5”)

15

(6’ - 6”)

15

(6’ - 8”)

15 - 1/2

(6’ - 9”)

15 - 1/2

(7’ - 0”)

16

(7’ - 3”)

16 - 1/2

(7’ - 6”)

17

(7’ - 9”)

17 - 1/2

(8’ - 0”)

18

Number of Installed Spring Turns

LOCATION fOR

MARkING NuMBER

Of INSTALLED

SPRING TuRNS

bACk OF TORqUEMASTER

®

PlUS END bRACkET wARNINg TAg

PAWL kNOB IN LOWER

POSITION

END BRACkET

winding Springs Continued...

wARNINg

None

Starting with the left hand side, align
the counterbalance cable with one of
the slots in the drum wrap. Slide the
drum wrap over the drum until the tabs
snap between the cable drum and the
ratchet gear. Repeat for right hand side.

DRuM

(LEfT hAND)

GROOVE

IN DRuM

TABS

COuNTERBALANCE CABLE

26

Drum wrap Installation

Advertising