Wayne-Dalton TORQUEMASTER 46 - Manual (Page 5)

5
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Required
SAfETy GLASSES fLAT TIP SCREWDRIVER
1/4”, 3/8”, 7/16”, 1/2” &
9/16” WRENChES
1/2”, 9/16”, 5/8”
& SOCkET
PhILLIPS hEAD
SCREWDRIVER
PLIERS/WIRE CuTTERS RATChET WRENCh POWER DRILL
(2) SAWhORSES
GLOVES 7/16”, 1/2” SOCkET
DRIVER
hAMMER
VICE GRIPS
STEP LADDER
TAPE MEASuRE
LEVEL
(2) VICE CLAMPS
PENCIL
1/8”, 3/16”, 9/32”,
5/16”, 1/2” DRILL BITS
3” EXTENSION
Counterbalance spring tension must always be released before any attempt is made to start removing an existing door.
A POWERfuL SPRING RELEASING ITS ENERGy SuDDENLy CAN CAuSE SEVERE OR fATAL INjuRy. TO AVOID
INjuRy hAVE A TRAINED DOOR SySTEMS TEChNICIAN, uSING PROPER TOOLS AND INSTRuCTIONS, RELEASE
ThE SPRING TENSION.
for detailed information see supplemental instructions “removing an existing door/preparing the opening”. These instructions are
available at no charge from Wayne-Dalton Corp., P.O. Box 67, Mt. hope, Oh 44660, or at www.wayne-dalton.com.
hACkSAW
Removing an Existing Door
wARNINg
TORX BIT