Xircom Action Systems 1500 - Manual (Page 27)

GSA Operations
Document Number: 401-364
27
Imaging
Scanning an Image or a Text Document using the PageScan Scanner
To scan a picture using the page scanner:
CAUTION: The scanner is self-propelled. Do not force paper through the
scanner and do not force the scanner across a page. Damage to the scanner
may result.
CAUTION: You must lift up a crawling scanner to stop it. Please do not let it
fall off the table!
NOTE: If there is more than one scanning program open, then you will not be
able to scan. The solution to this problem is to close all scanning programs, then
proceed with the following steps.
• To attach the scanner to the base, orient the scanner so that the Logitech logo
faces you. Align the vertical plastic guide pin on the right side with the end of
the base that has a slot in which the guide pin will fit. Slide the right side with
the pin down onto the base first, then press the left side down until it snaps into
place.
• To remove the scanner from the base, lift up on the left side (Logitech emblem
facing you) of the scanner until it snaps out of place and then remove the base.
• Make sure the PageScan Scanner is connected. If it is not, then connect the
scanner cable to the connector located on the orange panel of the GSA Unit
case. There is only one cable carrying both power and data.
• Place the picture or text document to be scanned in either of the following
positions:
• With the scanner base attached, insert the document just into the feed rollers at
the front of the scanner with the paper guides and stop. Do not push paper
further.
OR
• With the scanner base detached, place the scanner section on top of the
document (Do not push or pull the scanner. It will crawl over the document on
its own).
• The scanner application program will automatically open a window similar to
that shown in Figure 16. If it does not open, double-click the Imaging folder
located on the Desktop. From there double-click PageScan Control
Center.