Xircom Action Systems 1500 - Manual (Page 47)

GSA Operations
Document Number: 401-364
47
Scanner
Nothing scans
• Ensure the scanner connector is properly inserted into the GSA Unit – especially
check that the connector is straight when it is inserted into the GSA Unit case.
• Close all scanning programs. Afterwards start the scanning program you want to
use.
The paper jams
• Remove creases before inserting the paper.
• Ensure the bottom to the scanner is properly attached.
Scanned Images or Text comes out weird
• Insert the Logitech calibration sheet (looks like a grayscale sheet) into the feed rollers.
This will bring up the Logitech PageScan Control Center. From the menu bar, select
Scanner -> Recalibrate Scanner. The scanner should scan the card and recalibrate the
scanner.
I need to scan a large document (larger than 8.5 inches wide)
• Remove the bottom of the scanner and ensure the cable to the scanner is
completely extended from the GSA Unit. Put the scanner at one end of the
document to be scanned and start the scanning software. As the scanner pulls
itself across the document, monitor the cable to ensure it does not become
entangled. You must lift up the crawling scanner to stop it. Please do not let it
fall off the table!