Zebra Technologies P100iTM - Manual (Page 14)

10 P100i User’s Manual 980590-001 Rev. A
Printer Installation
Installing the P100i Printer
Installing the P100i Printer
1. Place the printer in a location that allows easy access to all sides. The printer should never
be operated while resting on its side or upside down
2. Remove the yellow CAUTION label from the back of the printer.
Caution • Do not power the printer with USB attached to your computer until the driver
has been installed or until prompted by the driver.
Caution • Limit electrical power supplied to the P100i Printer to 24 VDC. Limit excess
current draw to 16 amps or less, using an associated circuit breaker or other such
device. Never operate the printer in a location where operator, computer, or printer can
get wet. Personal injury could result. The printer must be connected to an earthed
electrical power supply and properly protected against electrical surges and grounding
faults. The power supply pack can only be replaced by the same product from the
manufacturer.