Resetting to factory defaults, Printing a configuration card – Zebra Technologies P100iTM User Manual
Page 59
Advertising
Troubleshooting
Troubleshooting the Ethernet Connection and Adapter
980590-001 Rev. A
P100i User’s Manual
55
Resetting to Factory Defaults
To reset the Ethernet Adapter configuration parameters to the factory defaults:
1.
Press the Ethernet Reset Button, and hold it in while turning the printer power
ON
( | ).
2.
Keep the Panel Button pressed until the Status Indicator light turns
GREEN
.
3.
Then release the Ethernet Switch.
Printing a Configuration Card
To print a configuration card, press and hold the Ethernet Switch until a card starts to print.
Ethernet Reset Button
Advertising