Zanussi ZCM 1000X - Manual (Page 11)

11
REPLACING THE HOB BURNER PARTS
1. Crown to burner body
Do not force the crown on to the burner body.
Make sure the hole in the crown is over the
electrode. Check that the location pegs sit in the
slots in the body. Check that the crown can be
moved slightly from side to side.
2. Cap to crown
Place the burner cap centrally on top of the
crown with the enamel side up. Move sideways
and front to back to check the cap is properly
fitted.
3. Check for ignition
If a burner will not light, check the crown and cap
positions.
REPLACING THE ULTRA RAPID BURNER
CAP
The Ultra Rapid burner cap is in two parts.
1. Ensure the aluminium part is fitted correctly
before placing the enamelled cap in the same
orientation on top.
2. Move the cap sideways and front to back to
check the cap is properly fitted.
TO REPLACE THE PAN SUPPORT
1. Position the location pegs on the pan support
over the location points on the hotplate and
gently ease the pan support into place.
Ensure the pan support has been carefully
dried and is correctly fitted before use.
CARE AND CLEANING THE WOODEN
SURROUND OF THE APPLIANCE
·
Clean timber surfaces with a sparing amount of
warm water, a drop of washing up liquid and a
well wrung cloth.
·
Always mop up spills of water and other liquids
straight away. Do not allow liquids to stand on
wooden surfaces for any period of time.
CLEANING THE OVEN AND OVEN
FURNITURE
For cleaning instructions relating to the oven and its
furniture please refer to the ZBM 799 Instruction
Book.