Zanussi ZCM 1000X - Manual (Page 17)

17
MOVING THE APPLIANCE
You may damage some soft or badly fitted floor
coverings when you move the appliance. The floor
coverings under the appliance should be securely
fixed so it does not ruck up when you move the
appliance across it.
Two people may be required to move the appliance.
1. Remove all oven furniture.
2. Close the oven door.
3. Lift the appliance by holding the bottom of the
wooden side panels.
4. This appliance is heavy and care must be taken
when moving it. Do not try to move the
appliance by the pulling the door handle.
IMPORTANT – SAFETY REQUIREMENTS
This appliance must be installed in accordance with the Gas Safety (Installation and Use) Regulations Current
Editions and the I.E.E. Wiring Regulations. Detailed recommendations are contained in the following British
Standard Codes of Practice – BS.6172, BS.5440: Part 2 and B.S.6891. All British Standards must be ‘Current
Editions’.
PROVISION FOR VENTILATION
This appliance is not connected to a combustion products evacuation device. It shall be installed and connected
in accordance with the current installation regulations. Particular attention shall be given to the relevant
requirements regarding ventilation.
The room containing the appliance should have an air supply in accordance with BS.5440: Part 2 Current Edition.
All rooms require an openable window or equivalent and some rooms will require a permanent vent as well. For
room volumes up to 5m
3 an air vent of 100cm 2 is required: for room volumes between 5m 3 and 10m 3 an air vent of
50cm 2 is required. If the room has a door that opens directly to the outside, no air vent is required. For room
volumes that exceed 11m
3
no air vent is required. If there are other fuel burning appliances in the same room,
BS.5440: Part 2 Current Edition should be consulted to determine the requisite air vent requirements.
Prolonged intensive use of the appliance may call for additional ventilation, for example opening a window, or
more effective ventilation, for example increasing the level of mechanical ventilation where present.
INSTALLATION INSTRUCTIONS