Xerox 3200MFP - Manual (Page 200)

10 Troubleshooting
10-12 Xerox Phaser 3200MFP
Stop Pressed The Stop/Clear button
has been pressed
during a copy or fax
operation. Try again.
Toner Empty The print cartridge has
run out. Replace the print cartridge with
a new one. See
Replacing the
Print Cartridge on page 9-7 .
Note: A used cartridge will not
reset this message.
Toner Low The toner is almost
empty. Take out the print cartridge and
gently shake it. By doing this,
you can temporarily re-establish
printing operations. See
Redistributing Print Cartridge
Toner on page 9-6 .
Hsync Error There is a serious
problem in your
machine.
Turn the machine off and back
on. If the problem persists,
please call for service.
Scan Stopped The Stop/Clear button
has been pressed
during a network
scanning job.
Try again.
Aborting.. Scan to email job is
aborted by pressing
Stop/Clear button.
Try again.
Send Error (SMTP) There is a problem in
SMTP.
Change to the available server.
SMTP Server
CONN. Failure
Send Error (DNS) There is a problem in
DNS.
Configure the DNS setting.
Authentication
Failure
Invalid SMTP acconut
or password entered by
the user.
Enter the correct acconut or
password.
Invalid SMTP
Account
Invalid account is
entered.
Enter the correct acconut.
Authentication
Required
There is a problem in
SMTP authentication.
Configure the authentication
setting.
Send Stopped The Stop/Clear button
has been pressed
during a sending mail.
Try again.
Display Meaning Suggested Solutions