Xerox 3200MFP - Manual (Page 76)

5 Copying
5-8 Xerox Phaser 3200MFP
Collation Copying
This special copy feature is available only when you load documents in the
ADF.
1. Load the documents to be copied in the ADF.
2. Press Favorite Copy until “Copy Collate” appears on the bottom line of
the display and press Enter.
3. If necessary, customize the copy settings, including Lighten/Darken and
original type, by using the control panel buttons. See “Selecting Copy
Options” on page 5-5.
4. Press Start to begin copying.
Auto Fit Copying
This special copy feature can be applied only when you place a document on
the document glass. If a document is detected in the ADF, Auto Fit copying
does not work.
1. Place the document to be copied on the document glass, and close the
cover.
2. Press Favorite Copy until “Auto Fit” appears on the bottom line of the
display and press Enter.
3. If necessary, customize the copy settings, including Lighten/Darken and
original type, by using the control panel buttons. See “Selecting Copy
Options” on page 5-5.
4. Press Start to begin copying.
NOTE: You cannot adjust the copy size using the Reduce/Enlarge button
while Auto Fit copying is enabled.
1
2
3
1
2
3
A