Zanussi ZUQ 875 - Manual (Page 33)

33
CARE AND CLEANING
Before cleaning always allow the appliance to
cool down.
CLEANING MATERIALS
Before using any cleaning materials on your appliance,
check that they are suitable and that their use is
recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as they
may dull the surface finishes. Harsh abrasives should
also be avoided.
CLEANING THE OUTSIDE OF THE
APPLIANCE
Do not use abrasive cleaning materials e.g. abrasive
cream cleaners, wire wool pads or scourers on painted or
printed finishes as damage may occur. Regularly wipe
over the control panel, control knobs, handles, doors and
appliance sides using a soft cloth and hot soapy water.
To prevent streaking, finish with a soft cloth.
Stainless Steel cream cleaners are abrasive and should
be avoided as they may dull the surface finish. Any
spillage on the stainless steel finish must be wiped off
immediately.
Do not attempt to remove any of the control knobs
from the appliance as this may cause damage and
is a safety hazard.
Under no circumstances should the door assembly
be detached from the product for cleaning.
CLEANING THE CONTROL KNOBS AND
HANDLES
It is strongly recommended that only hot soapy water is
used for cleaning the control knobs and door handles.
ANY OTHER CLEANING MATERIALS WILL DULL THE
SURFACE FINISH.
REMOVING AND REPLACING THE
WIREWORK RUNNERS
The wirework runners in the grill and oven can be
removed for cleaning.
1. Remove all shelves and furniture from the oven.
2. Hold the wirework at the bottom, unclip from the
cavity side and gently pull towards the centre of
the oven.
3. Unhook the runner at the top and remove from
the cavity.
4. To replace the runners, hook the wirework side
runner into the cavity, slide back and press into
place.
Ensure the wirework runners are firmly in
position before replacing the oven shelves.
SIDE PANEL
CAVITY CENTRE