Zanussi ZUQ 875 - Manual (Page 42)

42
•
This appliance must not be installed on the wooden
base board.
•
Enquiries regarding the installation of the cooker
point, if required, should be made to your Regional
Electricity Company to ensure compliance with their
regulations.
•
The cooker point should be outside the cabinet but
within 2m of the appliance to make it accessible to
switch off the appliance in case of an emergency.
•
To protect the hands, wear gloves when lifting the
oven into its housing.
Do not lift the appliance by the handles.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried out
before the appliance is connected to the mains supply
and re-checked after fitting.
PREPARING CABINET FOR FITTING OF
OVEN
•
Make sure the space between the cabinets is the
correct size for the appliance to be fitted (Ref. Fig. 5 &
6).
•
The plinth board spanning the space into which the
appliance is to be installed should be removed.
•
If the size is between adjacent cabinets is 605-
610mm, then the cabinets should be modified so that
the recommended dimension of at least 600-605mm
is maintained. The modification should ideally be
localised to ensure that after screw fixment the oven is
securely fixed into position.
•
The cabinets must be stable and level by firmly
securing it to the wall or floor. If necessary, make
arrangements to ensure the shelf upon which the
oven will rest is level.
•
The adjacent cabinets must be stable and level by
firmly securing to the wall or floor. If necessary, make
arrangements to ensure the work surface below
which the oven will rest is level.
•
Drill two pilot screw holes into the sides of the
adjacent cabinets, in the positions indicated by Fig. 5
.
•
Fit the appliance mounting brackets using the two
holes indicated in Fig. 7 to the adjacent cabinets ( Ref.
Fig. 5 & 6).
•
Check that the mounting brackets are level. They can
be adjusted if necessary by using the extra holes at
the ends of the brackets. Once the brackets are level,
drill a pilot hole through the central hole in the bracket
and fit the remaining screw.
Fig. 5
Fig. 6
Fig. 7