Zanussi ZUQ 875 - Manual (Page 43)

43
HOW TO FINISH UNPACKING
•
Place packed appliance next to the space in which it
will be installed.
•
Remove the appliance packing except for bottom tray
which should be left in position until the appliance is
ready to be fitted into its cabinet.
•
NOTE: It is imperative that the appliance is left in the
base to protect both the appliance and the floor.
•
Ensure the owner is given these operating
instructions.
Important: Switch off at mains, miniature circuit
breaker and if appropriate, remove fuse before
commencing any electrical work.
TO REMOVE COVER OF MAINS TERMINAL
From the rear of the appliance, remove mains input
terminal cover to gain access to terminal block.
•
First remove retaining screw with pozidrive
screwdriver. See Fig. 8.
•
Prise cover loose using screwdriver in position (1) then
lever off with screwdriver in position (2) at either side.
See Fig. 9.
•
Lift cover and remove screw from cable clamp. See
Fig. 10.
Fig. 8
Fig.9
Fig.10