Zanussi ZUQ 875 - Manual (Page 36)

36
TO REPLACE THE OUTER GLASS
1.
Holding the door glass panel with both hands, gently
place the locators into the holes of the brackets at
the bottom of the oven door.
2. Holding the door glass with your left hand, use your
right hand to open the oven door. Bring the door
gently towards the glass panel ensuring the screw
location holes line up.
3. Place the trim in the correct position on the top of the
grill door.
4. Hold the glass in place with one hand and insert the
cross head screws with washers into the location
holes with the other hand. Give the screws one turn
to ensure the glass is secure.
5. Tighten the screws positively with a Pozidrive
screwdriver before closing the oven door.
DO NOT attempt to use the oven without the
glass being in place.
TO CLEAN THE INNER GLASS DOOR
PANELS
Clean the inner glass door panels using a soft cloth
and hot soapy water to which a little washing up liquid
has been added. If the inner panel is heavily soiled,
hob cleaner may be used. Do not use abrasive
cleaning materials on the door glass. Ensure that all
parts are well rinsed and thoroughly dried before
attempting to replace the glass.
REPLACING AN OVEN LIGHT BULB
Disconnect the appliance from the electricity
supply before replacing the bulb.
The type of bulb required is a 300°C, 25 watt small
Edison Screw.
1. Make sure the appliance is cool before you replace
a bulb
2. Open the oven door and remove the shelves and
wirework runners.
3. Pull the glass bulb cover towards you and then pull
it off. If necessary use a screwdriver to carefully
lever off the cover, taking care not to damage the
oven cavity.
4. Unscrew the bulb by turning it to the left.
5. Fit a new bulb and then replace the glass bulb
cover.
6. Refit the wirework runners and replace the oven
shelves.
7. Restore the electricity supply and reset the time of
day.